The Composite formwork beam I tec 20 is a solid-web beam pursuant to DIBT (German Institute of Building Technology) building-industry approval with a special structure and innovative polyurethane end reinforcement for low material quantities and extended service life.

Art.-No. 001

The Doka Floor prop Eurex 20 top has an integrated impact protector for reliable protection against mechanical damage. This long-lasting steel tube floor prop guarantees a minimum load capacity of 20 kN at any extension length and corresponds to prop class D, B/D or C/D according to EN 1065.

Art.-No. 024

The Doka Floor prop Eurex 30 top has an integrated impact protector (except for length 550) for reliable protection against mechanical damage. This long-lasting steel tube floor prop guarantees a minimum load capacity of 30 kN at any extension length and corresponds to prop class C/E according to EN 1065.

Art.-No. 025

Floor prop for heavy slab loads.

Art.-No. 028

Self-cleaning threadbar

Art.-No. 032

Framed panel with Xlife sheet and form-tie points on the inside for crane-assisted forming of large areas. The panel is secured with a tie-rod system consisting of form ties that can be operated from one side.

Art.-No. 035

Framed panel with Xlife sheet for crane-assisted forming of large areas.

Art.-No. 036

Forming right-angled outside corners, stop-ends and column formwork.

Art.-No. 037

Forming right-angled inside corners.

Art.-No. 038

Forming right-angled inside corners.

Art.-No. 039

Forming right-angled outside corners.

Art.-No. 040

Bracing gangforms, infills and corners and forming stop-ends.

Art.-No. 041

Steel tube with wall thickness of 3.2 mm.

Art.-No. 042

Grating for safety barriers on the formwork or on the structure.

Art.-No. 043

Tapered form tie, operated from one side only, for Framed formwork Framax Xlife plus.

Art.-No. 046

Forming acute-angle and obtuse-angle inside corners.

Art.-No. 048

Forming acute-angle and obtuse-angle outside corners.

Art.-No. 049

Forming right-angled shaft inside corners.

Art.-No. 051

Framed panel with Xlife sheet for craneless forming.

Art.-No. 056

Forming right-angled outside corners, stop-ends and column formwork.

Art.-No. 057