The Composite formwork beam I tec 20 is a solid-web beam pursuant to DIBT (German Institute of Building Technology) building-industry approval with a special structure and innovative polyurethane end reinforcement for low material quantities and extended service life.

Réf. 001

Der widerstandsfähige Schalungsträger in Vollwandkonstruktion

Hochwertig, robust, langlebig – Der Doka-Träger H20 top P ist ein widerstandsfähiger Vollwandträger mit einem Steg aus Spezial-Flachpressplatte, der in Wand- und Deckenschalungssystemen eingesetzt werden kann. Die innovative Endverstärkung aus Polyurethan reduziert Beschädigungen und garantiert eine bis zu dreifach längere Lebensdauer.

Réf. 003

The extra long-lived floor prop with impact protector

The robust and long-lived Eurex 20 top floor prop impresses with a high minimum load capacity of 20 kN and complies with prop classes D, B/D or C/D in accordance with standard EN 1065. The integrated impact protector reliably protects the outer tube from mechanical damage and significantly increases the life span of the tubular steel prop.

Réf. 024

The extra long-lived floor prop with impact protector

The robust and long-lived Eurex 30 top floor prop impresses with a high minimum load capacity of 30 kN and complies with prop classes C/E in accordance with standard EN 1065. The integrated impact protector reliably protects the outer tube from mechanical damage and significantly increases the life span of the tubular steel prop.

Réf. 025

The lightweight aluminium floor prop with high load capacity

The floor prop Eurex 100 plus is a high-strength construction prop made of aluminium with a load capacity up to 128 kN, type-tested and approved in accordance to with approval Z-8.312-868. The floor prop also impresses with its easy handling thanks to quick-motion adjustment screw jack.

Réf. 028

Self-cleaning threadbar

Réf. 029

Self-cleaning threadbar

Réf. 032

Framed panel with Xlife sheet and form-tie points on the inside for crane-assisted forming of large areas. The panel is secured with a tie-rod system consisting of form ties that can be operated from one side.

Réf. 035

Framed panel with Xlife sheet for crane-assisted forming of large areas.

Réf. 036

Forming right-angled outside corners, stop-ends and column formwork.

Réf. 037

Forming right-angled inside corners.

Réf. 038

Forming right-angled inside corners.

Réf. 039

Forming right-angled outside corners.

Réf. 040

Bracing gangforms, infills and corners and forming stop-ends.

Réf. 041

Steel tube with wall thickness of 3.2 mm.

Réf. 042

Grating for safety barriers on the formwork or on the structure.

Réf. 043

Tapered form tie, operated from one side only, for Framed formwork Framax Xlife plus.

Réf. 046

Forming acute-angle and obtuse-angle inside corners.

Réf. 048

Forming acute-angle and obtuse-angle outside corners.

Réf. 049

Forming right-angled shaft inside corners.

Réf. 051