Réf. 328460600

The U head is designed to be installed at the top of a scaffold. Particularly for Shoring applications where beams are required to be supported. Alternatively the U head can be used at the base of the scaffold by turning it upside down.

Réf. 328450600

The 4 way screw jack is designed to be installed at the top of a scaffold. Particularly for shoring applications where one more beams are required to be supported.

Réf. 306030780

The Swivel base jack is used as a starting base for a scaffold. It is adjustable in height and angle to allow for compensation on uneven surfaces so that a level scaffold is always attainable.

Réf. 306010600

The base jack is used to adjust the height of the scaffold. For base jack 60cm height adjustability is 40 – 450 mm.

Réf. 301270000

The base collar with a single rosette is placed on the base jack and forms an easy base for the rest of the scaffold. The base collar makes the alignment of a modular structure easier.

Réf. 301280000

The Leg lock, used in pairs, is designed to attach to the bottom rosette of the top Standard and to the top rosette of the bottom Standard. This joins the standards together in preparation for suspended or lifted scaffold applications.

Réf. 301311630

The Guardrail standards are used to create openings for access & egress and the ability to attach a Safety Gate.

Réf. 335030000

The Toggle pin is designed to lock two Standards together to resist uplift.

Réf. 307070100

The Castor Wheel is designed to provide mobility to a medium to large size scaffold tower allowing the tower to roll across a flat surface.

Réf. 335020000

Pin for securing standard-to-standard connections.

Standards with presseded spigot are used as “verticals” to transmit loads to the ground. Rosettes are welded every 50cm which allow to create a connection between different elements. These standards are not to be used for suspended scaffolds! Standards are available in incremintle lengths from 0.50m to 4.00m.

Réf. 844

Réf. 333040005

The Ballast weight holder secures to the Standard to prevent overturning when used with Ballast weights.

Réf. 333040015

The Ballast weight is installed onto the Ballast weight holder.

Réf. 691360000

Standards hanging without spigot are used as “verticals” to transmit loads to the ground. The fact that they don´t have spigots, allows them to be used for shoring applications. Standards are available in incremintle lengths. Rosettes are welded every 50cm which allow to create a connection between different elements. In order to join 2 standards a Spigot needs to used. These standards are to be used for suspended Scaffolds

Réf. 845

Réf. 397320000

The Base jack handle is installed ontop of a Base collar or Standard to prevent uplift in Rebar scaffold configurations.

Réf. 306110004

The base jack retention prevents the kicker lift to fall off when hoisting the scaffold. It has a terminal wedge and a half coupler allowing to high versatility of the component.

Réf. 301300014

Rosette clamp horizontal allows a Ledger to be connected anywhere along the length of a bay. Allowing to create an intermediate transom.

Réf. 301300004

The Rosette clamp allows to add an additional rosette to any point along the vertical (tube Standard). It can accomodate up to six connection points.

Réf. 305032004

The Spigot adapter with clamp-bolt is used for creating handrails smaller than the bay length.