Art.-No. 335040000

Spigots for hanging scaffolds are necessary for connecting standards without spigots in suspended scaffolds (2 bolt axis per connection).

Art.-No. 307070100

The Castor Wheel is designed to provide mobility to a medium to large size scaffold tower allowing the tower to roll across a flat surface.

Art.-No. 589149000

Integrable inter-panel connector for DokaXlight panels. Not a substitute for the standard Frami clamp.

Art.-No. 757560001

Start package of 100 m² Doka Xlight Aluminium panel formwork

Art.-No. 757560002

Anchor parts for Start package of 100 m² Doka Xlight Aluminium panel formwork

Art.-No. 757560003

Fitting timber for Start package of 100 m² Doka Xlight Aluminium panel formwork

Art.-No. 757560004

Multitrip Packaging Units for Start package of 100 m² Doka Xlight Aluminium panel formwork

The outer guardrail is used to shield the outer side of the staircase tower. Outer guardrails are available for stair lengths of 2.57m, 3.07m. The outer guardrail has a Swivel Wedge Terminal that allows to fix it to the rosette.

Art.-No. 455

Installing form-tie components at an angle of 45 °.

Art.-No. 459

Securing System ladder XS to column formwork.

Art.-No. 460

The Gap filler plank is designed to span small openings in the Ringlock platform or between bays. They can also be used to overalp on circular scaffolds and perform the angular connection. They are fized with a plastic plug that is provided with them. They are available in two widths: 0.32m and 0.19m and un 3 different lengths: 1.00m, 1.50m and 2.00m.

Art.-No. 468

Measuring cable with three measuring points. The cable connects to the Concremote cable sensor and is cast into the concrete as a lost part.

Art.-No. 480

Prevents adhesion between concrete and cone with insulation up to 11 cm thick.

Art.-No. 486

Release agent specially for smooth formwork surfaces.

Art.-No. 496

Framed element made of aluminium with Xlife sheet for craneless forming of right-angle outside corners, stop-ends and column formwork.

Art.-No. 512

Corner element made of aluminium with Xlife sheet for craneless forming of right-angle inside corners.

Art.-No. 524

Truss ledgers have the same function as the normal ledgers: They are used as horizontals to connect standards, to transfer loads from platforms into standards and for making side protection of the scaffold. But due to reinforced design, they are able to transfer higher loads than normal ledgers. Double ledgers are available in lengths 1.40m, 1.57m, 2.07m, 2.57m, 3.07m.

Art.-No. 527

Plywood sheet made of Chinese eucalyptus with 240 g/m² phenolic-resin film coating on both sides. The phenolic resin bond of the sheet passes a 72-hour boiling test. The edges are sealed with acrylic-resin varnish.

Art.-No. 533

The bracket is used to create an extended platform outside the scaffold and to add a "cantilever" to the construction. Brackets are available in lengths 0.39m, 0.73m and 1.09m.

Art.-No. 543

Ledgers are used as horizontals to connect standards and to transfer loads from platforms into standards. Ledgers are also used for making side protection of the scaffold. Ledgers are available in lengths 0.15m, 0.39m, 0.73m, 1.04m, 1.09m, 1.40m, 1.57m, 2.07m, 2.57m, 3.07m.

Art.-No. 549