Art.-No. 306010600

The base jack is used to adjust the height of the scaffold. For base jack 60cm height adjustability is 40 – 450 mm.

Art.-No. 301270000

The base collar with a single rosette is placed on the base jack and forms an easy base for the rest of the scaffold. The base collar makes the alignment of a modular structure easier.

Steel planksare used to create a working platform in a scaffold. They are placed directly onto the ledgers and secured with the integrated lift-out guard. Steel planks are available with two widths 0.19m and 0.32m and in lengths 0.73m, 1.09m, 1.40m, 1.57m, 2.07m, 2.57m, 3.07m.

Art.-No. 559

Steel toe boards are mounted on working platforms to prevent material from falling down. These Toeboards are galvanized and not yellow.

Art.-No. 561

Standards with presseded spigot are used as “verticals” to transmit loads to the ground. Rosettes are welded every 50cm which allow to create a connection between different elements. These standards are not to be used for suspended scaffolds! Standards are available in incremintle lengths from 0.50m to 4.00m.

Art.-No. 844

The bracket is used to create an extended platform outside the scaffold and to add a "cantilever" to the construction. Brackets are available in lengths 0.39m, 0.73m and 1.09m.

Art.-No. 543

Ledgers are used as horizontals to connect standards and to transfer loads from platforms into standards. Ledgers are also used for making side protection of the scaffold. Ledgers are available in lengths 0.15m, 0.39m, 0.73m, 1.04m, 1.09m, 1.40m, 1.57m, 2.07m, 2.57m, 3.07m.

Art.-No. 549

Bay braces are essential to increase the vertical stiffness of the scaffold! For stabilizing the outer plane of the scaffold, parallel and perpendicular to the facade, vertical braces are used. Vertical braces are placed in at least every 5th bay on every lift and in every end bay perpendicular to the facade. Diagonals are available for 1.00m, 1.50m and 2.0m heights, and bay lengths of 0.73m, 1.09m, 1.40m, 1.57m, 2.07m, 2.57m, 3.07m.

Art.-No. 574

Truss ledgers have the same function as the normal ledgers: They are used as horizontals to connect standards, to transfer loads from platforms into standards and for making side protection of the scaffold. But due to reinforced design, they are able to transfer higher loads than normal ledgers. Double ledgers are available in lengths 1.40m, 1.57m, 2.07m, 2.57m, 3.07m.

Art.-No. 527