DK sealing cap made of plastic

Art.nr. 214

Storage and transport device for Dokadek panels.

Art.nr. 223

not painted

Art.nr. 233

For supporting and aligning wall formwork.

Art.nr. 239

Triangular ledge with soft plastic lips for close fit to the surface of the panel. Used for making no-nails outside corners and column formwork with universal panels.

Art.nr. 260

Triangular ledge with soft plastic lips for close fit to the surface of the panel. Used for making no-nails outside corners and column formwork with universal panels.

Art.nr. 278

Height-adjustable connections between load-bearing tower and superstructure in combination with Split nut B for primary beams (e.g. multi-purpose walings, steel girders).

Art.nr. 297

L = 50 mm for FB-S

Art.nr. 309

Connecting Scaffold tubes 48.3mm at any angle to the vertical tubes of load-bearing tower frames.

Art.nr. 341

Fibre-concrete

• Is glued into the opening of the sealing cap taper with KarPox
• water-impermeable
• flush-closing
• also available with polished visible surface

Art.nr. 348

Bearing plate for connectors with form-tie angles up to 15 °.

Art.nr. 349

Art.nr. 699360830

Sealing cone for fair-faced concrete positioning cone.

Een verpakking bestaat uit 50 stuks.

Art.nr. 699410500

Een verpakking bestaat uit 100 stuks.

Art.nr. 589164000

Can be pushed over the end face of the panel (no nails needed). With column formwork and for forming outside corners, it is used with the universal panel (integrated slot grid for universal fixing bolts).

Art.nr. 586646000

Storage and transport device for Protective barriers Z.

Installing form-tie components at an angle of 45 °.

Art.nr. 459

The sensor is for taking measurements on horizontal concrete components (bottom slab, floor slab, etc.).

Art.nr. 479

Measuring cable with three measuring points. The cable connects to the Concremote cable sensor and is cast into the concrete as a lost part.

Art.nr. 480

The cable sensor can be deployed for various applications depending on customer requirements. Concremote wall sensing unit or Concremote cable can be connected.

Art.nr. 481

The calibration box cube is for calibrating the type of concrete used and consists of 3 cube moulds 15x15x15 mm.

Art.nr. 482