Réf. 580485000

Closure between 2 folding platforms and corner solution.

Steel tube with wall thickness of 3.2 mm.

Réf. 042

Réf. 583012000

Storage and transport device for small items

Réf. 581120000

Expendable form-tie component for single-sided formwork tying.

Réf. 581448000

Tightening and loosening cone screws.

Réf. 581692000

Securing cantilever positioning cones when it is not possible to drill through the formwork sheeting.

Réf. 583016000

Storage and transport device.

Réf. 586151000

Storage and transport device.

Réf. 581961000

Connector in use with anchor plates and tie rods.

Réf. 581966000

Connector with captive support plate used with tie rods.

Réf. 581984000

Expendable form-tie component for single-sided tying.

Réf. 580579000

Releasing the positioning cones.

Réf. 581699000

Positioning cone for suspension cone with larger bearing surface.

Réf. 581971000

Suspending Folding platforms A, B and K.

Réf. 682004000

For connecting two Scaffold tubes 48.3mm at an angle of 90°.

Réf. 581858000

Pushes on to form ties.

Réf. 834013010

Steel tube with bent wire for securing the Meshguard panel in position. Can be used to set Meshguard panels higher, if required, in combination with slab formwork.

Réf. 834013020

Anchor bolt for securing the necessary attachment to the structure. Requires a pre-drilled hole.

Steel mesh panel used in combination with Guardrail posts to secure the slab edges. Two guardrail posts have to be pre-installed to support each panel. During installation the slab edge is not secured, so every worker must wear a personal fall arrest system (PFAS).

Réf. 313

Steel post with fixing at bottom. Secured by anchor bolts at edge of concrete slab or by Clamp H20 EP at edge of slab formwork. Support the Meshguard panels to create all-round edge protection.

Réf. 317