Storage and transport device for Dokadek panels.

Art.nr. 223

Holding Dokadek panels in the building edge zone.

Art.nr. 224

Framed panel made of aluminium with Xlife sheet for craneless forming.

Art.nr. 231

Supporting formwork sheets at closures between tableforms.

Art.nr. 238

For supporting and aligning wall formwork.

Art.nr. 239

Stripping aid between two panels of the inside formwork.

Art.nr. 255

Triangular ledge with soft plastic lips for close fit to the surface of the panel. Used for making no-nails outside corners and column formwork with universal panels.

Art.nr. 260

Panel connection in the outside corner and with column formwork and for attaching universal walings, for example, and other parts to the formwork.

Art.nr. 261

Triangular ledge with soft plastic lips for close fit to the surface of the panel. Used for making no-nails outside corners and column formwork with universal panels.

Art.nr. 278

Attaching a toeboard to the Handrail post XP 1.20m.

Art.nr. 279

Height-adjustable connections between load-bearing tower and superstructure in combination with Split nut B for primary beams (e.g. multi-purpose walings, steel girders).

Art.nr. 297

Tip-up protector for Doka formwork beams during sheeting operations.

Art.nr. 303

At form-tie points, protects the form-ply against damage.

Art.nr. 307

Expendable form-tie component for two-sided formwork tying.

Art.nr. 320

Connecting Scaffold tubes 48.3mm at any angle to the vertical tubes of load-bearing tower frames.

Art.nr. 341

For securing plates and accessory parts, for example to multi-purpose walings.

Art.nr. 344

Bearing plate for connectors with form-tie angles up to 15 °.

Art.nr. 349

Art.nr. 319022575

The Alum ladder hatch deck 257cm acts as a lightweight, extra wide scaffold acess deck which incorporates a Ladder. It is available only with 2.57m.

Art.nr. 306010600

The base jack is used to adjust the height of the scaffold. For base jack 60cm height adjustability is 40 – 450 mm.

Art.nr. 301013000

Standards with presseded spigot are used as “verticals” to transmit loads to the ground. Rosettes are welded every 50cm which allow to create a connection between different elements. These standards are not to be used for suspended scaffolds! Standards are available in incremintle lengths from 0.50m to 4.00m.