Art.-No. 589283000

For sealing the open form-tie point made by the Framax Xlife plus fair-faced concr. cone 87mm in the concrete.

Art.-No. 580267000

For making rigid corner plates at any angle. After the formwork has been plumbed, two Half splice plates are welded at the predefined angle.

Art.-No. 582831000

Making bolted joints of strength class 8.8.

Art.-No. 581464000

Prevents concrete from penetrating inside the jacket tube.

Art.-No. 588932000

For sealing form-tie sleeves of the holding formwork.

Art.-No. 588935000

For sealing Monotec tie holes in the concrete.

Art.-No. 581858000

Pushes on to form ties.

Expendable form-tie component for single-sided tying. Length: 115 mm

Art.-No. 116

Art.-No. 589288000

For sealing the form-tie points in the concrete.

Prevents concrete from escaping at the form-tie point.

Art.-No. 212

Seals the formwork on the concrete side and prevents the concrete from bleeding.

Art.-No. 213

Triangular ledge with soft plastic lips for close fit to the surface of the panel. Used for making no-nails outside corners and column formwork with universal panels.

Art.-No. 260

Triangular ledge with soft plastic lips for close fit to the surface of the panel. Used for making no-nails outside corners and column formwork with universal panels.

Art.-No. 278

Installing form-tie components at an angle of 45 °.

Art.-No. 459

Self-cleaning threadbar

Art.-No. 030

Art.-No. 581966000

Connector with captive support plate used with tie rods.

Self-cleaning threadbar

Art.-No. 029

Prevents adhesion between concrete and cone with insulation up to 11 cm thick.

Art.-No. 486