Diagonal anchor for anchoring the Supporting construction frame "Variable".

Art.-No. 199

Bearing plate for connectors.

Art.-No. 201

Prevents concrete from escaping at the form-tie point.

Art.-No. 212

Seals the formwork on the concrete side and prevents the concrete from bleeding.

Art.-No. 213

DK sealing cap made of plastic

Art.-No. 214

For supporting and aligning wall formwork.

Art.-No. 239

Closing holes in the concrete.

Art.-No. 241

Triangular ledge with soft plastic lips for close fit to the surface of the panel. Used for making no-nails outside corners and column formwork with universal panels.

Art.-No. 260

Triangular ledge with soft plastic lips for close fit to the surface of the panel. Used for making no-nails outside corners and column formwork with universal panels.

Art.-No. 278

Connecting Scaffold tubes 48.3mm at any angle to the vertical tubes of load-bearing tower frames.

Art.-No. 341

Fibre-concrete

• Is glued into the opening of the sealing cap taper with KarPox
• water-impermeable
• flush-closing
• also available with polished visible surface

Art.-No. 348

Bearing plate for connectors with form-tie angles up to 15 °.

Art.-No. 349

Art.-No. 699360830

Sealing cone for fair-faced concrete positioning cone.

Art.-No. 699410500

Art.-No. 589164000

Can be pushed over the end face of the panel (no nails needed). With column formwork and for forming outside corners, it is used with the universal panel (integrated slot grid for universal fixing bolts).

Art.-No. 586646000

Storage and transport device for Protective barriers Z.

The sensor is for taking measurements on horizontal concrete components (bottom slab, floor slab, etc.).

Art.-No. 479

Measuring cable with three measuring points. The cable connects to the Concremote cable sensor and is cast into the concrete as a lost part.

Art.-No. 480

The cable sensor can be deployed for various applications depending on customer requirements. Concremote wall sensing unit or Concremote cable can be connected.

Art.-No. 481

The calibration box cube is for calibrating the type of concrete used and consists of 3 cube moulds 15x15x15 mm.

Art.-No. 482